Anecho Ø1 First run Winter 2026

Silence is a material

Ø1 does not muffle the world — it subtracts it. 41 dB of cancellation, a 40 mm beryllium driver, 60 hours of playback. Mass — 289 grams.

  • 41 dBActive cancellation
  • 40 mmBeryllium driver
  • 60 hBattery life
  • 289 gWeight, ready to wear

01

Silence

We did not measure sound. We measured its absence.

An anechoic chamber is a room with the echo taken out of it. Metre-long wedges absorb 99.4 % of the energy that reaches them, and sound dies where it was born. Inside, you can hear your own heart working.

Ø1 was designed in one. Eight microphones read the outside field 48 000 times a second, and the onboard processor builds its exact counter-phase in 190 microseconds — faster than the wave reaches the eardrum.

World

Inside an anechoic chamber: walls, floor and ceiling covered in acoustic wedges converging on a vanishing point

Silence

57 dB SPL
at the eardrum

Drag the edge

A demonstration of the principle. Figures are Ø1 rated values under typical metro noise.

World audible

02

Material

Two hundred and eighty-nine grams with nothing left to remove

Not one screw on the outside. Not one part put there for looks. Three materials, each chosen for one reason — it does not ring.

Macro: the chamfer of the graphite aluminium cup and its seam with the bone leather pad

Cup

Each cup is milled from a solid billet of 6063 aluminium — forty-two minutes apiece. The wall varies in thickness: 1.8 mm where stiffness is needed, 0.9 mm where mass is.

6063 aluminium · class II anodising · 42 min each

Macro: the bone nappa ear pad, its grain visible, with a soft fold
2.2

Ear pads

Nappa over variable-density memory foam: 60 kg/m³ along the skull line, 28 kg/m³ at the cheekbone. They come off with a 12° twist, no tool and no glue.

Nappa · 28–60 kg/m³ foam · twist to remove

Macro: the hinge and ground-titanium yoke entering the graphite cup
2.3

Yoke

Grade 5 titanium, ground along the load axis. The hinge sits on a nitrile rubber damper that kills headband vibration before it reaches the driver.

Grade 5 titanium · NBR damper · rated 30 000 cycles

03

Sound

One driver. No crossover.

The 40-millimetre driver: a champagne-gold diaphragm dome in a graphite basket with radial slots

Forty millimetres, the dome coated with 240 nanometres of beryllium. The first break-up mode sits beyond 44 kilohertz — past the point where sound is still sound. Below that line the diaphragm moves like a piston: no lag, no overtones, no crossover split.

Frequency response ± 1.5 dB

5 Hz 50 500 5 kHz 20 kHz 44 kHz
  • 44 kHzUpper limit
  • 0,02 %THD at 1 kHz
  • 100 dBSensitivity

04

Fit

Eight hours you will forget about

Dark studio profile: a person wearing Ø1 in the “Salt” finish, eyes closed
“Salt” finish

Clamping force was set not for an average head but for the worst case: 2.4 newtons — enough to hold the acoustic seal, little enough that you will not think about the headphones for eight hours.

  • 289 g

    Weight, ready to wear

    With pads and battery. 34 grams lighter than the previous frame thanks to the titanium yoke.

  • 2.4 N

    Clamping force

    Measured on a HATS dummy at 155 mm spread. Batch spread no greater than 0.15 N.

  • 22 mm

    Headband travel

    Twenty detented positions at 1.1 mm steps. The mechanism is rated for 30 000 cycles.

05

Specification

Every number here is measured, not promised

The protocol was taken from a production sample. Where a figure has a measurement condition, it sits next to the value, not in fine print below.

  1. 240nm Dome coating
  2. 190µs Counter-phase build
  3. 96kHz Wired path
  4. 45min Full charge

Driver

Type
Dynamic, 40 mm, dome with 240 nm beryllium coating
Range
5 Hz — 44 kHz
Impedance
32 Ω
Sensitivity
100 dB / mW
Ø1 range against the audible one

In lime — what the ear hears: 20 Hz to 20 kHz. Ø1 covers that band with headroom at both ends, so nothing has to be stretched at the edges.

Cancellation

Topology
Hybrid, 8 microphones
Field sampling
48 000 readings per second
Counter-phase
Built in 190 µs
Depth
Up to 41 dB under typical metro noise

Connectivity

Wireless
Bluetooth 5.4, two simultaneous pairings
Codecs
LDAC, aptX Lossless, AAC, SBC
Wired
USB-C 96 kHz / 24 bit, 3.5 mm analogue

Power

Battery
1 480 mAh
Charging
45 minutes to full, USB-C PD 20 W
Rated life
800 cycles
Battery life — measured at 50 % volume

Cancellation off60 hours

Ø mode on40 hours

5 minutes of charge6 hours

Cup

Materials
6063 aluminium, Grade 5 titanium, nappa
Mass
289 g
Finishes
“Graphite”, “Salt”

Ø1 · measurement protocol · revision C Figures are for a production sample

06

Pre-order

First run — twelve hundred units

Shipping from 14 February 2026. In the box: a hard case, a USB-C cable and a braided 3.5 mm analogue cable. The finish is chosen when the order is confirmed.

78 900 ₽ 92 400 ₽ Pre-order · −15 %

Concept demonstration: the form sends nothing and stores nothing you type.